LG LS65SXN Bedienungsanleitung PDF herunterladen (Seite 19)

19

EN

Connecting the Water Line

(For Plumbed models Only)

Accessories

Water Filter Water Tube

Installation Parts

Water Supply Requirements

A cold water supply with water pressure

between 138 kPa and 827 kPa (1.4-8.4 kgf/cm²)

is required to operate the water dispenser. If the

refrigerator is installed in an area with low water

pressure (below 138 kPa), you can install a

booster pump to compensate for the low

pressure.

If a reverse osmosis water filtration system is

connected to your cold water supply, the water

pressure to the reverse osmosis system needs

to be a minimum of 138 kPa to 827 kPa

(1.4-8.4 kgf/cm²)

WARNING

• Unplug the appliance before carrying out any

work on connecting the water line. Failure to

do so may cause electric shock.

• Only connect the water line to a cold water

supply. Failure to do so may cause the water

filter to malfunction. Water hammer (water

banging in the pipes) in house plumbing can

cause damage to appliance parts and can

lead to water leakage or flooding.

• Connecting the water line must only be

installed by a qualified plumber and in

accordance with local legislation and

regulations governing water quality.

NOTE

• This water line installation is not covered by

the appliance warranty.

Connecting to the Appliance

1

Unscrew the metal threaded collar nut at

the back of the appliance and place it over

one end of the water tube.

2

Firmly push the water tube onto the water

inlet valve and tighten up the collar nut.

Connecting to the Water Filter

There are two types of filters. The methods of

connection are different. One has a threaded

plastic nut fitting and the other uses a self

locking push fit connectors. The filter is marked

with the direction of the water flow from the

water tap to the appliance.

<Nut Type>

1

Cut the tubing end squarely, then check for

and remove any burrs. Push the fitting onto

the end of tubing, making sure the end is

fully sealed.

(1)

(2)

Colored line in the water filter

2

Tighten the screw cap until the colored line

in the water filter is no longer visible.

EN

3

Unlock the fitting by twisting until the

colored line in the water filter is visible and

a clicking sound is heard. Press the collet

squarely against the face of the tubing to

remove it from the fitting.

(2)

(1)

(3)

(2)

<Push fit Connector Type>

1

Firmly push the water tube connected from

the appliance into the end that has the

arrow pointing outward. Push the tube all

the way in (approx. 10-12 mm).

2

After inserting the tube securely into the

filter, fit the locking clip into position under

the pull up collar.

3

Repeat on the other end of the filter using

the remainder of the water tube.

Checking the Water Connection

1

Turn on the water supply and switch on the

appliance. Carefully check all fittings for

possible leaks due to poorly fitted hoses.

2

Press and hold the Water Filter button for

three seconds. That resets the Replacement

Filter icon. The new water filter has been

activated.

3

Place a cup under the water dispenser to

verify that water is flowing through the

appliance.

4

Check the connecting tube and joints for

leaks once again.

5

The water filter should be fixed at a

appropriate place where it is easy to reach

for replacement purposes.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 47 48

Kommentare zu diesen Handbüchern

Keine Kommentare