LG dv1000 Bedienungsanleitung PDF herunterladen (Seite 21)

Operation with tape

Playing a tape

You will only be able to load and eject video cassettes

when your VCR is plugged into the mains.

Your VCR may also play back recordings from

NTSC tapes (on PAL TV).

Getting a better picture

When a cassette is inserted and playback started, the

automatic tracking function works to get the best

possible picture automatically. If the quality of the

recording is poor, repeatedly press

on the

remote control to manually adjust the tracking until

any distortions have been removed. Press numbered

0 on the remote control to switch automatic tracking

back on again.

Picture search will only continue for about 3 min-

utes, after which your VCR will return to normal

playback. During picture search, logic search, and

CM Skip the sound is mute and there will be some

noise streaks on the picture.

Make sure that you have correctly connected your

VCR as described earlier in this book.

Turn on your TV and select the video channel for

video playback.

Press POWER to turn on your VCR.

Insert the video cassette into your VCR.

The video cassette should have the window side

facing up and the arrow facing away from you.

Press PLAY to start playing your tape.

If you load a video cassette which has had its

record protection tab removed, playback of the

cassette will start automatically.

AUTO TRACKING

Your VCR will automatically adjust the tracking to

give the best picture quality.

Press PAUSE/STEP to pause a picture.

Press PAUSE/STEP repeatedly to advance the still

picture frame by frame.

If you hold down FORWARD, the picture will be

slowed down at about 1/19 times the normal

playback.

Tapes can be paused for up to 5 minutes. After 5

minutes your VCR will stop the tape to prevent

damaging the tape or your VCR .

Press

D or E to reduce the vertical tremble

during still picture.

Press PLAY to continue playing your tape.

Picture search:

During playing back press either FORWARD or

BACKWARD to this will enable you to rapidly wind

the tape (7 times normal playback speed) and see

where you are on the tape.

Logic search:

During fast forwarding or rewinding press and hold

FORWARD or BACKWARD the picture will be

played back at 7 times normal playback speed.

Slow motion playback, Shuttle :

During playing back or still picture press F or G.

You can reach the following playback speeds.

(-7xplay, -3xplay, -play, still, 1/19 slow, play, 2xplay,

7xplay)

To switch off the slow motion and shuttle, press the

desired function.

During slow motion and shuttle, the noise bars may

appear on the picture according to the status of

tape.

If distortions can be seen in the picture, reduce

them with

D or E.

Press STOP to end playback.

Press EJECT.

If the end of the tape is reached, your VCR will stop

playback automatically, rewind, stop, eject the tape.

CM (Commercial Message) Skip:

This feature enables you during playback of a tape to

skip a commercial break in a few seconds, then resume

normal playback.

While tape is playing press CM SKIP on the remote

control to skip commercial (or another programme

material).

Repeatedly press CM SKIP to skip:

1 Press 30 seconds

2 Press 60 seconds

3 Press 90 seconds

4 Press 120 seconds

5 Press 150 seconds

6 Press 180 seconds

OPR (Optimum Picture Response)

This feature automatically improves playback picture

quality by adjusting your VCR to the condition of the

tape.

Press i.

Press 1 or 2 to select OPR.

Press OK.

Press

repeatedly to select: OFF, SOFT or

SHARP.

Please note you may only set OPR when

playing a tape.

Press i to remove the menus.

REC

Dr.

VCR

Pr-12

ACMS

SET

TIME

DATE

SYS-

TEM

OPR

OSD

OFF

OSD

16:9

4:3

NIC

OFF

SOFT

SHARP

OPERATION

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 36 37

Kommentare zu diesen Handbüchern

Keine Kommentare

LG dv1000 Bedienungsanleitung Seite 21

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für CD Spieler LG dv1000