LG WT7100CW Bedienungshandbuch PDF herunterladen (Seite 40)

40 TROUBLESHOOTING

Error Codes

Problem Possible Cause Solutions

If the balance is not successful, this

error will be displayed.

• The automatic attempt to rebalance the load was

not successful. The cycle has been paused to

allow the load to be manually adjusted.

The load is too small.

• Small loads may need additional items to be

added to allow the washer to balance the load.

Heavy articles are mixed with lighter

items.

• The load may have heavy items loaded with

lighter items. Always try to wash articles of

somewhat similar weight to allow the washer

to evenly distribute the weight of the load for

spinning.

The load is out of balance.

• Manually redistribute the load if articles have

become tangled preventing the automatic

rebalancing from working properly.

Water supply faucets are not fully

open.

• Make sure that the water faucets are fully open.

Water line hoses are kinked,

pinched, or crushed.

• Make sure that the hoses are not kinked or

pinched. Be careful when moving the washer.

Water inlet lters are clogged. • Clean the inlet lters. See Maintenance section.

Water supply pressure to faucet or

house is too low.

• Check another faucet in the house to make sure

that household water pressure is adequate and

ow is not restricted. Disconnect the inlet hose

from the washer and run a few gallons of water

through the hose to ush the water supply lines.

If ow is too low, contact a plumber to have the

water lines repaired.

Water supply connected with leak-

limiting hoses.

• Hoses designed to limit leaks can trip falsely and

prevent the washer from lling. The use of leak

limiting hoses is not recommended.

Drain hose is kinked, pinched, or

clogged.

• Make sure the drain hose is free of clogs or kinks

and is not pinched behind or under the washer.

Drain discharge is more than 96

inches (2.4 m) above bottom of

washer.

• Move the end of the drain hose so it’s lower

than 96 inches (2.4 m) above the bottom of the

washer.

The Control Lock function is on

to prevent anyone from changing

cycles or operating the appliance.

• Turn off Control Lock in the control panel. See

Control Lock under Option Buttons.

Special drain feature

• If the washer is paused during a cycle for more

than 4 minutes, the cycle will be cancelled and

any water remaining in the tub will be drained.

• This is not an error code. It indicates that the

drain function is operating.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 49 50

Kommentare zu diesen Handbüchern

Keine Kommentare

LG WT7100CW Bedienungshandbuch Seite 40

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Waschmaschinen LG WT7100CW