LG ARNU24GSCL2.EMBALEU Bedienungsanleitung

P/NO : MFL67798115www.lg.comINSTALLATION MANUALAIR CONDITIONER • Please read this installation manual completely before installing the product.• Insta

10INSTALLATIONENGLISHBarCopper pipeClamp handleRed arrow markConeYokeHandleBar"A"InclinedInside is shiny without scratchesSmooth all roundEv

INSTALLATION11ENGLISHCAUTIONInstallation Information. For right piping.Follow the instruction above.!Bad case- Following bending case from right to le

12INSTALLATIONENGLISH<Right side piping>2 Secure the cable onto the control boardwith the cable retainer.3 Tape the tubing pipe, drain hose and

INSTALLATION13ENGLISHWrap the insulation materialaround the connecting portion.1 Overlap the connection pipe insulation ma-terial and the indoor unit

14INSTALLATIONENGLISHChecking the DrainageTo check the drainage.1 Pour a glass of water on the evaporator.2 Ensure the water flows through the drainho

INSTALLATION15ENGLISHInstallation of filters1 Pull out the [Allergy free filter + Triple Fil-ter] from the separately packed plastic bag.2 Detach the t

16ENGLISHINSTALLATIONWiring Connection- Connect the wires to the terminals on the control board individually according to the outdoorunit connection.-

17ENGLISHINSTALLATIONInstallation of Wired Remote Controller1. Please fix tightly using provided screw after placing remote controller setup board on

18ENGLISHINSTALLATION4. Please connect indoor unit and remote controller using connecting cable.5. Please use extension cable if the distance between

19ENGLISHINSTALLATIONInstaller Setting -ThermistorThis is the function to select the temperature sensor to judge the room temperature. Function Code

2TIPS FOR SAVING ENERGYENGLISH• Do not cool excessively indoors. This may be harmful for your health and may consume moreelectricity.• Block sunligh

20ENGLISHINSTALLATIONGroup Control SettingGroup Control 1Wired remote controller 1 + Standard Indoor Units Dip Switch in PCB (Cassette and Duct Type i

21ENGLISHINSTALLATIONWired remote controllers + Standard Indoor UnitsIt is possible to control N indoor units by wired remote controller M units. (M+N

22ENGLISHINSTALLATIONGroup Control 3Mixture connection with indoor units and Fresh Air Intake UnitIn case of connecting with standard indoor unit and

23ENGLISHINSTALLATIONRemote ControlWired remote controller 2 + Indoor unit 11. It is possible to connect two wired remote controllers with one indoor

24ENGLISHINSTALLATIONAccessories for group control settingSlaveMas terMaste rPZCWRCG3Maste r S lavePZCWRC2Indoor unit 2 EA +Wired remote controller* P

IMPORTANT SAFETY INSTRUCTIONS3ENGLISHIMPORTANT SAFETY INSTRUCTIONSREAD ALL INSTRUCTIONS BEFORE USING THE APPLIANCE.Always comply with the following pr

4IMPORTANT SAFETY INSTRUCTIONSENGLISH• Do not install the product on a defective installation stand.- It may cause injury, accident, or damage to the

TABLE OF CONTENTS5ENGLISH3 IMPORTANT SAFETY INSTRUCTIONS6 INSTALLATION PARTS6 INSTALLATION TOOLS7 INSTALLATION MAP8 INSTALLATION8 Select the best Loca

6INSTALLATION PARTSENGLISHINSTALLATION TOOLSINSTALLATION PARTSNameQuantity ShapeInstallation plate1 EAType "A" screw5 EAType "C" s

INSTALLATION MAP7ENGLISHINSTALLATION MAPVinyl tape (Wide)• Apply after carrying out a drainage test.• To carry out the drainage test, remove the

8INSTALLATIONENGLISHSelect the best Location - There should not be any heat or steam nearthe unit.- Select a place where there are no obstaclesaround

INSTALLATION9ENGLISHOutside diameterADrill a Hole in the Wall- Drill the piping hole with a ø65mm hole coredrill. Drill the piping hole at either the