LG OLED65E6P Bedienungsanleitung

Please read this manual carefully before operating your set and retain it for future reference.www.lg.comP/NO : MFL69361142 (1604-REV00-00)Printed in

10ENGLISH CAUTION•  Avoid touching the screen at all times, as this may result in damage to the screen.•  Do not move the TV by holding the cable hold

ENGLISH11 WARNINGIf a television is not positioned in a suciently stable location, it can be potentially hazardous due to falling. Many injuries, par

12ENGLISH NOTE•  To remove the stand, hold the top and bottom of stand, then pull it out while also lowering it as shown below. (Only OLED55/65E6*)121

ENGLISH13USB connectionSome USB Hubs may not work. If a USB device connected using a USB Hub is not detected, connect it to the USB port on the TV dir

14ENGLISHB Returns to the previous level. Clears on-screen displays and returns to TV viewing. (HOME) Accesses the Home menu. (INPUT) Changes the inp

ENGLISH15B Adjusts the volume level. Scrolls through the saved programmes. (MUTE) Mutes all sounds. (SEARCH) Search for content such as TV prog

16ENGLISHLicensesSupported licenses may dier by model. For more information about licenses, visit www.lg.com.Open source software notice informationT

ENGLISH17SpecicationsWireless module specification•  As band channels can vary per country, the user cannot change or adjust the operating frequency.

18ENGLISHRegulatoryWARNING! Never place a television set in an unstable location. A television set may fall, causing serious personal injury or death.

2ENGLISHSafety instructionsPlease read these safety precautions carefully before using the product. WARNINGDo not place the TV and/or remote control i

MODELSERIALRecord the model number and serial number of the TV.Refer to the label on the back cover and quote this information to your dealer when req

OWNER’S MANUALEXTERNAL CONTROL DEVICE SETUPwww.lg.comPlease read this manual carefully before operating the set and retain it for future reference.

2ENGENGLISH2KEY CODESKEY CODES• This feature is not available for all models.Code (Hexa)Function NoteCode (Hexa)Function Note00 CH +, PR + R/C Button

3ENGENGLISH3EXTERNAL CONTROL DEVICE SETUPEXTERNAL CONTROL DEVICE SETUP• Image shown may differ from your TV.Connect the USB to Serial converter/RS-23

4ENGENGLISH4EXTERNAL CONTROL DEVICE SETUPPhone jack Type• You need to purchase the phone-jack to RS-232 cable required for the connection between the

5ENGENGLISH5EXTERNAL CONTROL DEVICE SETUPCommunication Parameters• Baud rate : 9600 bps (UART)• Data length : 8 bits• Parity : None• Stop bit : 1

6ENGENGLISH6EXTERNAL CONTROL DEVICE SETUPTransmission / Receiving ProtocolTransmission[Command1][Command2][ ][Set ID][ ][Data][Cr][Command 1] : Firs

7ENGENGLISH7EXTERNAL CONTROL DEVICE SETUP* Commands may work differently depending on model and signal.01. Power (Command: k a) ► To control Power *On

8ENGENGLISH8EXTERNAL CONTROL DEVICE SETUPData Min : 00 to Max : 64Ack [i][ ][Set ID][ ][OK/NG][Data][x]09. Tint (Command: k j) ► To adjust the screen

9ENGENGLISH9EXTERNAL CONTROL DEVICE SETUP1 0 05th Band1 0 1 0 020(decimal)Acknowledgement [v][ ][Set ID][ ][OK/NG][Data][x]* It depends on model, and

ENGLISH3Do not plug too many electrical devices into a single multiple electrical outlet. Otherwise, this may result in re due to over-heating.Do not

10ENGENGLISH10EXTERNAL CONTROL DEVICE SETUPNumber - 22 : Antenna TV (DTV) – Don’t Use Physical Channel Number - 26 : Cable TV (CADTV) - Don’t Use

11ENGENGLISH11EXTERNAL CONTROL DEVICE SETUP24. Input select (Command: x b) (Main Picture Input) ► To select input source for main picture.Transmission

12ENGENGLISH12EXTERNAL CONTROL DEVICE SETUP27. Auto Configure (Command: j u) (Depending on model) ► To adjust picture position and minimize image sha

4ENGLISHNever touch this product or antenna during a thunder or lighting storm. You may be electrocuted.Never touch the wall outlet when there is lea

ENGLISH5 CAUTIONInstall the product where no radio wave occurs.There should be enough distance between an outside antenna and power lines to keep the

6ENGLISHSignal from Remote Control can be interrupted due to external/internal lighting eg Sunlight, uorescent lighting. If this occurs turn o light

ENGLISH7Avoid touching the screen or holding your nger(s) against it for long periods of time. Doing so may produce some temporary or permanent disto

8ENGLISHDisplaying a still image for a prolonged period of time may cause image sticking. Avoid displaying a xed image on the TV screen for a long pe

ENGLISH9 CAUTION•  Do not use any unapproved items to ensure the safety and product life span.•  Any damage or injuries caused by using unapproved ite